EAN-no.: 4260052638996
- Description
- Download
- CE Declaration of Conformity
- Video
The connection is easily set up and automatically restored via Bluetooth 4.0. The BTR series uses the Bluetooth protocol for headphones on your smartphone and does not affect the functionality of your Bluetooth hands-free car kit.
The BTR400 Bluetooth Receiver is designed for navigation and car stereo systems with RCA input and USB power supply.
With a 230V to USB power supply available as an accessory, you can also connect the BTR400 to your hi-fi system or TV in your home to stream music wirelessly via Bluetooth.
CONNECTIONS
- Sound output: Cinch (RCA)
- Power supply: USB input (5 VDC)
EQUIPMENT
- splash-proof, marine certified
- automatic power on
- QDL licensed Bluetooth 4.0 CRS I9chip (CSR8635)
- A2DP in highest EDR specification
- BT audio streaming also of lossless files such as Wave, Flac, Lossless, etc.
- Cinch (RCA) with signal output 1.0V
- SSID display name: BTR400
- 10m range
SMARTPHONE COMPATIBILITY
- Android
- Apple iOS
- Microsoft
OPTIONAL ACCESSORIES
PRC-1 AMPIRE Bluetooth remote control
55100-CINCH AMPIRE noise filter
W44947 AMPIRE 230 volt power supply unit
TECHNICAL DATA:
- Voltage: 5 volts DC
- Power consumption: <45mA
- Bluetooth 4.0
- CSR8635 chip
- Frequency range: 20Hz-20kHz
- Encoding: Low Complexity Subband Codec (SBC)
- Bit rate: up to 345kbps.
- Audio output voltage: 1V RMS
- Bluetooth 4.0 / Transmitting power <10mW EIRP
- Cable length: 300mm
- Housing dimensions: height: 20mm, width: 65mm, length: 50mm
BLUETOOTH APPROVAL:
- Declaration ID D025151
- Referenced Qualified Design ID 56386
- Listing Date 08 December 2014
PAIR YOUR DEVICE:
- make sure Bluetooth is switched on in your device
- switch on the ignition
- the LED (6) flashes blue (pairing mode)
- Select "BTR400" in the Bluetooth menu of your device to connect.
- after successful connection, the LED lights up permanently and a single beep sounds over the audio system
NOTE:
- up to 9 devices can be connected to the BTR400, but only one device can stream music at a time
- The BTR400 always remembers the last tuned-in device and connects automatically when switched on.
- a connection to another device must be done manually, as described above
- if the connected device is out of range for more than one minute, the connection is automatically interrupted and the BTR400 goes into pairing mode [the LED (6) flashes].
- can only be used in vehicles and not in continuous operation
OPERATION:
- all settings, such as volume, music selection and play/pause, are made on your unit
- the BTR400 can be installed out of sight as it has no controls or buttons to operate.