AMPIRE CAN-Bus Controller for Alarmsystems (CANpro)

This CAN bus interface you can install a car alarm or remote start systems in a modern car with CAN databus. The CAC200 interface can be installed in many vehicles. Before the installation, the CAC200 need a vehicle-specific firmware. To upload the firmware, you need the BL200 boot loader and a computer with USB port.


The following functions are possible depending on the type of vehicle:

IGNITION OUTPUT
FACTORY ALARM OUTPUT
FACTORY ALARM SIRENE INPUT
BONNET CONTACT OUTPUT
TRUNK CONTACT OUTPUT
TRUNK OPEN INPUT
DIRECTION LIGHT INPUT
DRIVER'S DOOR CONTACT OUTPUT
OTHER DOORS CONTACT OUTPUT
LOCK STATUS OUTPUT
PARKING BRAKE OUTPUT
BRAKE OUTPUT
ENGINE OFF OUTPUT
ENGINE ON OUTPUT
POWER WINDOWS OPEN INPUT
POWER WINDOWS CLOSE INPUT
POWER LOCK INPUT
POWER UNLOCK INPUT
POWER UNLOCK DRIVER DOOR INPUT


Important note:
Please check with the car list in the download section which vehicles are compatible. Not all features are on all vehicles and technically possible, of course, depending on equipment. Please check after installation if no malfunction and whether the data bus after falling asleep at least 45 minutes. The current draw of the locked vehicle before and after the installation of CAC200 should not increase significantly.


SPECIFICATIONS
External module voltage: 12V
Current draw on standby: 0,90 mA
Current draw when working: 28,00 mA 40,00 mA
Operating temperature range: -40°C +85°C
Number of analog input: 10
Number of analog output: 18
Number of supported CAN buses: 2
Speeds readed from digital buses: 33,33 kb/s 500 kb/s
Dimensions; 84,2 x 35,6 x 15,0 mm
Weight; 93g
E20 97R01/08 004015 00