AMPIRE Bluetooth® Receiver, USB powered, Cinch (RCA)

If you want to listen to your music, audio books or navigation from your smartphone wirelessly via Bluetooth® in your car, then the Bluetooth® receivers of the BTR series are the solution. You can upgrade to wireless A2DP Bluetooth® audio streaming on most navigation and car stereos with Ampire's Bluetooth® receivers.

The connection is easily set up and automatically restored via Bluetooth® 4.0. The BTR series uses the Bluetooth® protocol for headphones on your smartphone and does not affect the functionality of your Bluetooth® hands-free car kit.

The BTR400 Bluetooth® Receiver is designed for navigation and car stereo systems with RCA input and USB power supply.

With a 230V to USB power supply available as an accessory, you can also connect the BTR400 to your hi-fi system or TV in your home to stream music wirelessly via Bluetooth®.

CONNECTIONS
- Sound output: Cinch (RCA)
- Power supply: USB input (5 VDC)

EQUIPMENT
- splash-proof, marine certified
- automatic power on
- QDL licensed Bluetooth® 4.0 CRS I9chip (CSR8635)
- A2DP in highest EDR specification
- BT audio streaming also of lossless files such as Wave, Flac, Lossless, etc.
- Cinch (RCA) with signal output 1.0V
- SSID display name: BTR400
- 10m range

SMARTPHONE COMPATIBILITY
- Android
- Apple iOS
- Microsoft

OPTIONAL ACCESSORIES
PRC-2 AMPIRE Bluetooth® remote control
55100-CINCH AMPIRE noise filter
W44947 AMPIRE 230 volt power supply unit

TECHNICAL DATA:
- Voltage: 5 volts DC
- Power consumption: <45mA
- Bluetooth® 4.0
- CSR8635 chip
- Frequency range: 20Hz-20kHz
- Encoding: Low Complexity Subband Codec (SBC)
- Bit rate: up to 345kbps.
- Audio output voltage: 1V RMS
- Bluetooth® 4.0 / Transmitting power <10mW EIRP
- Cable length: 300mm
- Housing dimensions: height: 20mm, width: 65mm, length: 50mm

BLUETOOTH® APPROVAL:
- Declaration ID D025151
- Referenced Qualified Design ID 56386
- Listing Date 08 December 2014

PAIR YOUR DEVICE:
- make sure Bluetooth® is switched on in your device
- switch on the ignition
- the LED (6) flashes blue (pairing mode)
- Select "BTR400" in the Bluetooth menu of your device to connect.
- after successful connection, the LED lights up permanently and a single beep sounds over the audio system

NOTE:
- up to 9 devices can be connected to the BTR400, but only one device can stream music at a time
- The BTR400 always remembers the last tuned-in device and connects automatically when switched on.
- a connection to another device must be done manually, as described above
- if the connected device is out of range for more than one minute, the connection is automatically interrupted and the BTR400 goes into pairing mode [the LED (6) flashes].
- can only be used in vehicles and not in continuous operation

OPERATION:
- all settings, such as volume, music selection and play/pause, are made on your unit
- the BTR400 can be installed out of sight as it has no controls or buttons to operate.

LEGAL NOTICE
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries. Used with permission of the owner. aptX is a trademark of Qualcomm Technologies International, Ltd. registered in the United States and other countries. Used with permission of the owner. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Ampire Electronics GmbH&Co.KG is under license. Other trademarks and trade names are those of their respective owners.